8. Troubleshooting
Problem
Cause Solution
Web Interface shows error in the
processes “WiFi Access Point Daem on”
and/or “ DHCP Server”
Configuration file is corrupted Browse to th e Con figuration tab on the
Web Interface and press “Load Default
Settings”.
ClickShare Base U nit does not start up
correctly
Configuration file is corrupted Browse to the Configuration tab of the
Web Interface and press “Load Default
Settings”.
No LA N connection with the Base Unit Wrong IP address IP address is not within your LAN range.
DHCP is not enabled.
No W iFi connection with Base Unit
SSID not correct Enter the correct SS ID
Locate the problem you are ex periencing in the table below and apply the solution.
R5900023 CSE-200 11/04/2016
67
To Next Page
Loading...
