2. Safety
2.2 Important safety instructions
To prevent the risk of electrical shock
• This projector should be operated from an A C power source. E nsure that the mains voltage and capacity matches the p rojector
electrical ratings. If you are una ble to install the AC requirements, contact your electrician. Do not defeat the purpose of the
grounding.
• Installatio n according to the loc al electrical code and regulations by qualified technical personnel only.
• A readily accessible disconnect device must be incorporated externally to the equipmen t for removal of the power to the pr o-
jector cord .
• Warning: High leakage current. Earth connection essential b efore c onnecting supply.
• Do not allow anything to rest on the power cord. Do not locate this projector w here per sons will walk on the cord.
• Do no t op erate the projector w ith a damaged cord or if the projector has b een dropped or damaged - until it h as been exam ined
and approved for operation b y a qualified service technician.
• Position the cord so that it will not be tripped over, pulled, or c ontact hot surfaces.
• If an extension cord is necessary, a cord with a current rating at least equal to that of the projector should b e used. A cord rated
for less amperage than the projector may overheat.
• Never push objects of any k ind into this projector through cabinet slots as they m ay touch da ngerous voltage po ints or short
circuit parts that could res ult in a risk of fire or electrical shock.
• Do n ot expose this projector to rain or moisture.
• Do not im merse or expose this projector in w ater or other liquids.
• Do not spill liquid of any kind on this projector.
• Should any liquid or solid object fall into the cabinet, unplug the set and have it checked by qualified service personnel before
resuming operations.
• Do not disassemble this projector, always take it to a t rained service person when service or repair wor k is required.
• Do not use an accessory attachment which is not recommended by the m anufacturer.
• Lightning - F or added protection for this video product during a lightning storm, or when it is left unattended and unused for
long periods of time, remove all powe r from the projector. This will pr event damage to the projector due to lightning and AC
power-line surges.
R5906693 DP2K-E SERIES 19/06/2015
7
To Next Page
Loading...
Need help?
General
