Encore Presentation System • User’s Guide 249
6. System Setup
Restore from Flash Memory Card
oÉëíçêÉ=Ñêçã=cä~ëÜ=jÉãçêó=`~êÇ
Encore system setup: Step 6 (optional)
In this procedure, you will restore your system configuration from flash memory — provided
that you previously backed up your system to the flash memory card.
S Prerequisite — Ensure that you are familiar with the Backup/Restore
Menu
. In Chapter 5, refer to the “Backup/Restore Menu” section on
page 188 for details.
Use the following steps to restore your system from the flash memory card:
1. Ensure that your flash memory card is properly inserted in the Controller’s
MEMORY CARD slot.
2. In the System Keypad, press MISC to access the Miscellaneous Menu.
3. Press {BACKUP RESTORE} to display the Backup/Restore Menu.
4. Press {CHECK CARD} to display the Current Backup Menu.
~ Check the “Controller files backed up” section to confirm the types of
files present on the Flash Memory Card (e.g., System, Presets,
ScreenPRO-II).
~ Check the “VP/SPs backed up” section to confirm the IDs of the
processors that are backed up.
~ Press {BACK} to return to the Backup/Restore Menu.
5. On the Device line, select Ctrlr+VP+SP to perform a complete “restore.”
6. On the Controller Options line, select All.
7. On the VP/SP to Restore line, select All.
8. Press {RESTORE} to restore the selected system configuration.
At the conclusion of this procedure, your system is completely set up — exactly the way
that you left it when you performed a complete system “backup.” No further setup
operations are required.
Please continue with system operations. Refer to the “
Operations” chapter on page 279
for details.
6
To Next Page
Loading...
