320 Encore Presentation System • User’s Guide
7. Operations
Working with Transitions
tçêâáåÖ=ïáíÜ=qê~åëáíáçåë
This section provides instructions for performing a variety of transitions. The following
topics are discussed:
• Cut
• Mix
• Wipe
• Manual Transitions
`ìí
Cuts can be performed on both single screen and widescreen destinations.
Use the following steps to perform a Cut:
1. Set up the desired “look” in Preview.
2. In the Transition Section, press CUT to instantly cut the setup to Program.
Cuts can also be performed directly on Program in the following three modes:
• Modify Layers on Program is enabled. Refer to the "Modifying Layers On
Program" section on page 306 for details.
• Live Switch Program/Preview Mode is enabled. Refer to the "Using Live
Switch Program/Preview Mode" section on page 317 for details.
• Live Switch Source Mode is enabled. Refer to the "Using Live Switch
Program/Preview Mode" section on page 317 for details.
jáñ
A Mix (or Dissolve) can be performed on both single screen and widescreen destinations.
Use the following steps to perform a Mix:
1. Set up the desired “look” in Preview.
2. Preset the mode and transition rate:
a. In the System Keypad, press EFFECTS to display the Effects Menu.
b. Adjust the Transition Rate field, in 0.1 second increments.
c. In the Transition Type field, select Mix.
3. In the Transition Section, press AUTO TRANS to dissolve the setup to Program.
Cut
Auto
Trans
To Next Page
Loading...
