292 Encore Presentation System • User’s Guide
7. Operations
Working with Groups
råäÉ~êåáåÖ=~=dêçìé
Use the following steps to unlearn (completely clear) a group button — so that it no
longer lights:
1. Controller LC:
a. Clear all destinations on the Destination Bus (Clear + All).
b. Press and hold Learn.
c. Press the desired Group button. Here, you are essentially programming
the button with “no destinations.”
2. Controller SC:
a. Press and hold the Group button that you want to unlearn.
b. On the Destination Bus, toggle all destination(s) off.
c. Release the Group button.
dêçìé=kçíÉë
Please note the following points regarding groups:
• If you enable a group that fully contains all the destinations from another group,
both group buttons will light.
S Group 1 contains destinations 1 and 2, Group 2 contains destinations 3 and
4, and Group 3 contains destinations 1, 2, and 4. When you press the
Group 3 button by itself, it lights, and the Group 1 button also lights —
because both destinations in
Group 1 are fully included in Group 3.
To Next Page
Loading...
