Encore Presentation System • User’s Guide 55
3. Hardware Installation
Installation
páåÖäÉ=pÅêÉÉå=`çåÑáÖìê~íáçå
The figure below illustrates a block diagram of a single screen Encore configuration. Aux
destinations are not shown. Use this diagram for reference in the following procedure.
Figure 3-1. Block Diagram, Single Screen Encore Configuration
For this configuration, you will need:
Scaled
Sources
Unscaled
Sources
Controller SC or LC
PG 2
PVW
PG 1
M/E Inputs
Ethernet Switch
ProjectorProgram Preview
Encore Video Processor
To:
Routers
ScreenPRO-II
PresentationPRO-II
ImagePRO
Table 3-2. Equipment List, Single Screen Encore Configuration
Qty. Item Note
1 Encore Video Processor
1 Encore Controller Model LC or SC
1 Video Projector Customer supplied
2 DVI or Analog Monitors Program and Preview (customer supplied)
1 Ethernet Switch Customer supplied
2 Ethernet cables Customer supplied. Additional cables required for routers.
TBD Dedicated sources Analog, Video and/or DVI as required (customer supplied)
TBD Routers Analog, Video and/or DVI as required (customer supplied)
TBD Interconnect cables Analog, Video and/or DVI as required (customer supplied)
To Next Page
Loading...
