R5906167 /00 ImagePRO–4K Video Processor
14
3.1 ImagePRO–4K video processor overview
About the ImagePRO–4K video processor
Image 3-1: The ImagePRO–4K video processor
• Superb performance
In 2004 the Folsom ImagePRO revolutionized HD video processing for live events. The ImagePRO–4K
continues and extends that legacy, processing signals from XGA to full 4K60p 4:4:4 10-bit.
The latest I/O connectors enable you to convert HDMI 2.0, DP 1.2 and 3G – 12G SDI signals, while also
enabling output image rotation.
• Road-ready and reliable
Like all Barco image processing products, the ImagePRO–4K is built for life on the road. Assembled and
tested for extreme use and abuse, the ImagePRO–4K performs just as well at the gig as it does in the
shop. The live-source view on the front panel provides you with a clear view of the incoming signal giving
you the confidence you need to execute your event.
• LED at your fingertips
Need to slice and dice LED signals? The ImagePRO–4K can either chop up single inputs across several
connectors, or drive multiple walls from multiple sources. The LED set-up menu guides you through the
process.
• External control
You can remotely control all ImagePRO–4K features from a computer, using the Event Master Toolset
(EMTS) GUI. With the easy-to-use pages, menus and graphics of the EMTS, you can, for example,
upgrade system firmware, run test patterns, and control inputs and outputs. For more information about the
EMTS GUI, refer to “Event Master Toolset”, page 101.
You can also operate the ImagePRO–4K remotely using a Barco Event Master EC-30/50/200/210
controller.
3.2 ImagePRO–4K video processor features
Features of the ImagePRO–4K video processor
The ImagePRO–4K video processor provides the following features:
• Chassis
- 1 RU
- Two modular slots
◦ One slot supports Generation 2 Event Master Input cards.
◦ One slot supports Generation 2 Event Master Output cards.
- Single power input
- One Gigabit Ethernet (GbE) connection with a lockable Ethercon™ connector
• Control
- Front-panel control
- External control
◦ Event Master Toolset (EMTS) GUI
◦ Event Master EC-30/50/200/210 controller
• Inputs
- Input slot supporting Generation 2 Event Master input module
◦ Up to 6 inputs, with Tri-Combo Input card
◦ Up to 4 inputs with a quad connector card (will be supported in a future software release)
- External Genlock Reference Input on BNC connector
◦ Fixed internal 75 ohm termination
◦ SD NTSC or PAL Blackburst
General
To Next Page
Loading...
