101
About this chapter
As well as front panel control, the ImagePRO–4K can also be controlled remotely via Event Master Toolset
(EMTS), starting with version 6.1. This toolset software release adds control for the ImagePRO–4K. Starting
with version 6.2 and higher, EMTS can be used to control all Event Master processors, in addition to
ImagePRO–4K. Until version 6.2 is released, E2, S3, and Ex should continue to remain on version 6.0, or
earlier, firmware.
Overview
•
EMTS GUI: Configuration menu
• EMTS GUI: Programming menu
• ImagePRO–4K-specific controls
General
In the EMTS GUI, add the detected ImagePRO–4K processor as a new system and click the ImagePRO–4K
banner at the bottom of the represented unit. Next, click the contextual adjust tab to review the processor’s
main settings and reference output rate. The Setup tab allows the user to adjust the system mode, transition
type, logo index, and matte color. The Status tab shows the user if the there are any temperature warnings or
stalled fans.
Users can also map outputs to the Aux by clicking on the individual outputs and then updating them on the
Adjust tab.
R5906167 /00 ImagePRO–4K Video Processor
Event Master
Toolset
7
To Next Page
Loading...
