Error
Code
Error Message Possible Cause Error Resolution
E185
Infeed: possible
sticky dish at stopper
Possibly a plate has
become stuck at the
infeed stopper.
1. Remove the plate from the
infeed stopper.
2. Add the plate to a Destacker to
be processed by the Track
again.
3. Select Reset Error [F5].
4. Select Start [F2] to restart the
module.
E188
Infeed: receive
timeout (dish not
detected)
Possible obstruction.
1. Remove obstruction.
2. Select Reset Error [F5].
3. Select Start [F2] to restart the
module.
E191
Infeed: cylinder not in
position
E192
Infeed: cylinder not in
rest position
E193
Infeed: rotation motor
current limit overload
E194
Infeed: vacuum not
detected on scanner
The scanner lifting
cylinder may be dirty.
1. Check and clean the scanner
lifting cylinder.
2. Select Reset Error [F5].
3. Select Start [F2] to restart the
module.
E195
Infeed: conveyor
motor current limit
overload
Possible obstruction.
1. Remove obstruction.
2. Select Reset Error [F5].
3. Select Start [F2] to restart the
module.
E226
Outfeed: receive
timeout (dish not
detected)
E228
Outfeed: cylinder not
in position
E229
Outfeed: cylinder not
in rest position
E225
Outfeed: possible
sticky dish at stopper
Possibly a plate has
become stuck at the
outfeed stopper.
1. Remove the plate from the
outfeed stopper.
2. Add the plate to a Destacker to
be processed by the Track
again.
3. Select Reset Error [F5].
4. Select Start [F2] to restart the
module.
67
6 - Troubleshooting
To Next Page
Loading...
