25
DESCRIPTION OF OPERATION AND FUNCTIONS OF COMPONENTS
2 Doctor Unit Section
Function switch
• Use this switch for setting various working conditions.
The setup function changes in the sequence indicated below
each
time when this switch is pressed.
1. Dental timer time setup and motion
2. Doctor number selection
3. Flushout selection and operation
4. Key touch tone selection and change
5. Handpiece light switching-on timing selection
6. Dental timer time-out alarm tone selection
7. Micromotor limit rotation speed selection
8. Micromotor spray mode selection
9. Cupfiller and bowl flush interlocked action selection
○
Function of calculating and displaying the
micromotor gear ratio
Pressing and holding the function switch until ' Service mode
' is displayed on indicator, that can be enable or disable the
this display function. Refer to page 48 for setting procedure.
Store switch
• Use this switch for storing data and so forth:
1. Store micromotor preset mode. See page 48 for the setup
procedure of micromotor.
2. Store preset timer. See page 44 for the setup procedure.
3. Store micromotor recurrence mode at the time of power
on. See page 50 for setup procedure.
To Next Page