LR2000 Programming Manual V1.2
Underline mode can also be turned on or off by using ESC !. Note, however, that
the last received command is effective.
[Default] n = 0
[Reference] ESC !
ESC 2
[Name] Select default line spacing
[Format] ASCII ESC 2
Hex 1B 32
Decimal 27 50
[Description] Selects 4.23 mm (30×0.141 mm) line spacing.
[Notes] The line spacing can be set independently in standard mode.
[Reference] ESC 3
ESC 3 n
[Name] Set line spacing
[Format] ASCII ESC 3 n
Hex 1B 33 n
Decimal 27 51 n
[Range] 0 n 255
[Description] Sets the line spacing to [n × 200/380 × 0.141 mm]. If result is less than 3.384mm then
line spacing is set to 3.384mm.
[Notes] The line spacing can be set independently in standard mode.
In standard mode, the vertical motion unit (y) is used.
[Default] n = 62
[Reference] ESC 2
ESC = n
[Name] Set peripheral device
[Format] ASCII ESC = n
Hex 1b 3d n
Decimal 27 61 n
[Description] Set peripheral device：
bit 0： Off (Hex 00) printer disabled
On (Hex 01) printer enabled
bit 1-7：undefine
To Next Page
Loading...
