Bematech LR2000 - ESC G N; ESC J N; ESC M N

LR2000 Programming Manual V1.2
[Notes]  Only the least significant bit of n is enabled.
 This command and ESC ! turn on and off emphasized mode in the same way. Be
careful when this command is used with ESC !.
[Default] n = 0
[Reference] ESC !
ESC G n
[Name] Turn on/off double-strike mode
[Format] ASCII ESC G n
Hex 1B 47 n
Decimal 27 71 n
[Range] 0 n 255
[Description] Turns double-strike mode on or off.
 When the LSB of n is 0, double-strike mode is turned off.
 When the LSB of n is 1, double-strike mode is turned on.
[Notes]  Only the lowest bit of n is enabled.
 Printer output is the same in double-strike mode and in emphasized mode.
[Default] n = 0
[Reference] ESC E
ESC J n
[Name] Print and feed paper
[Format] ASCII ESC J n
Hex 1B 4A n
Decimal 27 74 n
[Range] 0 n 255
[Description] Prints the data in the print buffer and feeds the paper [n×0.141 mm (0.0055")].
[Notes]  After printing is completed, this command sets the print starting position to the
beginning of the line.
 The paper feed amount set by this command does not affect the values set by ESC
2 or ESC 3.
 In standard mode, the printer uses the vertical motion unit (y).
 Even when the set value exceeds the maximum with the BM sensor enabled in
standard mode, this command is effective. (BM =black mark.)
ESC M n
[Name] Select character font
[Format] ASCII ESC M n