Bematech LR2000 - ESC E N

LR2000 Programming Manual V1.2
ESC D n1...nk NUL
[Name] Set horizontal tab positions
[Format] ASCII ESC D n1...nk NUL
Hex 1B 44 n1...nk 00
Decimal 27 68 n1...nk 0
[Range] 1 n 255
0k 32
[Description] Sets horizontal tab positions.
 n specifies the column number for setting a horizontal tab position from the
beginning of the line.
 k indicates the total number of horizontal tab positions to be set.
[Notes]  The horizontal tab position is stored as a value of [character width n] measured
from the beginning of the line. The character width includes the right-side character
spacing, and double-width characters are set with twice the width of normal
characters.
 This command cancels the previous horizontal tab settings.
 When setting n = 8, the print position is moved to column 9 by sending HT.
 Up to 32 tab positions (k = 32) can be set. Data exceeding 32 tab positions is
processed as normal data.
 Transmit [n]k in ascending order and place a NUL code 0 at the end.
When [n]k is less than or equal to the preceding value [n]k-1, tab setting is finished
and the following data is processed as normal data.
 ESC D NUL cancels all horizontal tab positions.
 The previously specified horizontal tab positions do not change, even if the
character width changes.
 The character width is memorized for each standard mode.
[Default] The default tab positions are at intervals of 8 characters (columns 9, 17, 25,...) for Font
A (12×24).
[Reference] HT
ESC E n
[Name] Turn emphasized mode on/off
[Format] ASCII ESC E n
Hex 1B 45 n
Decimal 27 69 n
[Range] 0 n255
[Description] Turns emphasized mode on or off
When the LSB of n is 0, emphasized mode is turned off.
When the LSB of n is 1, emphasized mode is turned on.