Bematech LR2000 - ESC V N; ESC \ Nl Nh

LR2000 Programming Manual V1.2
ESC V n
[Name] Turn 90clockwise rotation mode on/off
[Format] ASCII ESC V n
Hex 1B 56 n
Decimal 27 86 n
[Range] 0 n 1, 48n 49
[Description] Turns 90clockwise rotation mode on/off
n is used as follows:
n
Function
0,48
Turns off 90clockwise rotation mode
1,49
Turns on 90clockwise rotation mode
[Notes]  This command affects printing in standard mode. However, the setting is always
effective.
 When underline mode is turned on, the printer does not underline 90clockwise-
rotated characters.
 Double-width and double-height commands in 90rotation mode enlarge
characters in the opposite directions from double-height and double- width
commands in normal mode.
[Default] n = 0
[Reference] ESC !, ESC
ESC \ nL nH
[Name] Set relative print position
[Format] ASCII ESC \ nL nH
Hex 1B 5C nL nH
Decimal 27 92 nL nH
[Range] 0 nL 255
0 nH 255
[Description] Sets the print starting position based on the current position using horizontal or vertical
motion units.
 This command sets the distance from the current position to [(nL + nH 256) ×
0.141 mm]
[Notes]  Any setting that exceeds the printable area is ignored.
 When pitch N is specified to the right:
nL+ nH ×256 = N
When pitch N is specified to the left (the negative direction), use the