Bematech LR2000 - 3.5 Ethernet IP Setup; 3.6 Driver Installation

LR2000 Programming Manual V1.2
2 Command List
A command set describes the behavior of the printer when sequences of bytes are received
through the communication interface. The command set available with LR2000 is ESC/POS®.
It is a standard defined by Seiko Epson Corporation. ESC/POS® commands can be classified as
executing or setting. An executing command cause the printer to execute something and does
not affect further incoming data. On the other hand, a setting command cause the printer to
change its internal flags that may affect incoming data. ESC/POS® commands supported by
LR2000 are summarized in the following table.
Type
Command
Name
Print Command
LF
Print and line feed
CR
Print and carriage return
HT
JMP to the next TAB position
ESC D n
Set horizontal tab positions
ESC J n
Print and Feed n dots paper
ESC d n
Print and Feed n lines
ESC = n
Toggle the printer online or offline
DC2 T
Printing test page
Line spacing
Command
ESC 2
Select default line spacing
ESC 3 n
Set line spacing
ESC a n
Select justification
GS L nL nH
Set the left blank margin with dots
ESC \nl nh
Set relative print position
GS W nL nH
Set printing area width
ESC $
Set absolute print position
Character
Command
ESC ! n
Select print mode(s)
GS ! n
Set or Cancel the double width and height
GS B
Turn white/black reverse printing mode
ESC V n
Turn 90°clockwise rotation mode on/off
ESC M n
Select character font
ESC G n
Turn on/off double-strike mode
ESC E n
Set or Cancel bold font
ESC SP n
Set the space between chars