Bematech LR2000 - FS W N

LR2000 Programming Manual V1.2
[Range] 0 n1 255
0 n2 255
[Description] Sets left- and right-side Kanji character spacing to n1 and n2, respectively.
 The left-side character spacing is [n1×0.141 mm], and the right-side character
spacing is [n2×0.141 mm].
[Notes]  This command sets the left- and right-side character spacing for normal-sized
characters. When double-width mode is set, the left- and right-side character
spacing is twice the normal value.
 The spacing which is set with this command can be set independently in standard
mode.
 In standard mode, the horizontal motion unit is used.
[Default] n1 = 0, n2 = 0
FS W n
[Name] Turn quadruple-size mode on/off for Kanji characters
[Format] ASCII FS W n
Hex 1C 57 n
Decimal 28 87 n
[Range] 0 n255
[Description] Turns quadruple-size mode on or off for Kanji characters.
 When the LSB of n is 0, quadruple-size mode for Kanji characters is turned off.
 When the LSB of n is 1, quadruple-size mode for Kanji characters is turned on.
[Notes]  Only the lowest bit of n is valid.
 In quadruple-size mode, the printer prints the same size characters as when
double-width and double-height modes are both turned on.
 When quadruple-size mode is turned off using this command, the following
characters are printed in normal size.
 When some of the characters on a line are different in height, all the characters on
the line are aligned at the baseline.
 When characters are enlarged in the horizontal direction, they are enlarged to the
right, based on the left side of the character.
 FS ! or GS ! can also select and cancel quadruple-size mode by selecting double-
height and double-width modes, and the setting of the last received command is
effective.
[Default] n = 0
[Reference] FS !, GS !