Bematech LR2000 - GS X N; GS P X y; Kanji Control Commands; FS! N

LR2000 Programming Manual V1.2
CODE39, ITF, CODABAR
[Default] n = 3
[Reference] GS k
GS x n
[Name] Set barcode printing left space
[Format] ASCII GS x n
Hex 1D 78 n
Decimal 29 120 n
[Description] The print bar code staring positions is: 0255
GS P x y
[Name] Set horizontal and vertical motion unit
[Format] ASCII : GS P x y
Hex : 1D 50 x y
Decimal : 29 80 x y
[Range] 0 x 255
0 y  255
[Description] This command sets the horizontal and vertical motion unit to 1 / x and 1 / y inches,
respectively. The default value are x = 180 and y = 360. When x and y are set to 0, the
default setting of each value is used.
KANJI CONTROL COMMANDS
FS ! n
[Name] Set print mode(s) for Kanji characters
[Format] ASCII FS ! n
Hex 1C 21 n
Decimal 28 33 n
[Range] 0 n 255
[Description] Sets the print mode for Kanji characters, using n as follows:
Bit
Off/On
Hex
Decimal
Function
0
－
－
－
Undefined.