Bematech LR2000 - GS C

LR2000 Programming Manual V1.2
These values are all character strings.
[Description] Selects a count mode for the serial number counter and specifies the value of the
counter.
 sa, sb, sn, sr and sc are all displayed in ASCII characters, using the codes for “0” to
“9.”
 sa and sb specify the counter range.
 sn indicates the stepping amount for counting up or down.
 sr indicates the repetition number with the counter value fixed.
 sc indicates the counter value.
[Notes]  Count-up mode is specified when:
sa < sb and sn 0 and sr 0
 Count-down mode is specified when:
sa > sb and sn 0 and sr 0
 Counting stops when:
sa = sb or sn = 0 or sr = 0
 When count-up mode is specified, sa is the minimum counter value and sb is the
maximum counter value. If counting up reaches a value exceeding the maximum, it
is resumed with the minimum value. If the counter value set by sc is outside the
counter operation range, the counter value is forced to convert to the minimum
value by executing GS c.
 When count-down mode is specified, sa is the maximum counter value and sb is
the minimum counter value. If counting down reaches a value less than the
minimum, it is resumed with the maximum value. If the counter value set by sc is
outside the counter operation range, the counter value is forced to convert to the
maximum value by executing GS c.
 Parameters sa to sc can be omitted. If omitted, these argument values are
unchanged.
 Parameters sa to sc must not contain characters, except 0 to 9.
 If an incorrect syntax is used, the corresponding parameter setting has no effect,
and the data after that is processed as normal data.
[Default] sa = 1, sb = 65535, sn = 1, sr = 1, sc = 1
[Reference] GS C 0, GS C 1, GS C 2, GS c
GS c
[Name] Print counter
[Format] ASCII GS c
Hex 1D 63
Decimal 29 99
[Description] Sets the serial counter value in the print buffer and increments or decrements the
counter value.