Bematech LR2000 - Esc L; Esc S

LR2000 Programming Manual V1.2
Decimal 27 12
[Description] When in page mode ESC FF prints all data in the print buffer in one time.The buffer
data is not deleted after being printed.
ESC L
[Name] Select page mode
[Format] ASCII ESC L
Hex 1B 4C
Decimal 27 76
[Description] Switches from standard mode to page mode.
[Notes]  This command is enabled only when processed at the beginning of a line in
standard mode.
 This command has no effect in page mode.
 After printing by FF is completed or by using ESC S, the printer returns to standard
mode.
 This command sets the position where data is buffered to the position specified by
ESC T within the printing area defined by ESC W.
 This command switches the settings for the following commands (in which the
values can be set independently in standard mode and page mode) to those for
page mode:
 Set right-side character spacing: ESC SP
 Select default line spacing: ESC 2, ESC 3
 Only valve settings is possible for the following commands in page mode; these
commands are not executed.
 Turn 90 degrees clockwise rotation mode on/off: ESC V
 Select justification: ESC a
 Turn upside-down printing mode on/off: ESC {
 Set left margin: GS L
 Set printable area width: GS W
 The printer returns to standard mode when power is turned on, the printer is reset,
or ESC @ is used.
[Reference] FF, CAN, ESC FF, ESC S, ESC T, ESC W, GS $, GS \
ESC S
[Name] Select standard mode
[Format] ASCII ESC S
Hex 1B 53
Decimal 27 83
[Description] Switches from page mode to standard mode.
[Notes]  This command is effective only in page mode.