Bematech LR2000 - GS! N

LR2000 Programming Manual V1.2
GS ! n
[Name] Select character size
[Format] ASCII GS ! n
Hex 1D 21 n
Decimal 29 33 n
[Range] 0 n 255
(1 vertical number of times 8, 1 horizontal number of times 8)
[Description] Selects the character height using bits 0 to 2 and selects the character width using bits
4 to 7, as follows:
Bit
Off/On
Hex
Decimal
Function
0
Character height selection. See Table 2.
1
2
3
4
Character width selection. See Table 1.
5
6
7
Table 1 Character Width Selection Table 2 Character Height Selection
Hex
Decimal
Width
Hex
Decimal
Width
00
0
1(normal)
00
0
1(normal)
10
16
2(double-width)
01
1
2(double-height)
20
32
3
02
2
3
30
48
4
03
3
4
40
64
5
04
4
5
50
80
6
05
5
6
60
96
7
06
6
7
70
112
8
07
7
8
[Notes] This command is effective for all characters (alphanumeric and Kanji), except for
HRI characters.
 If n is outside the defined range, this command is ignored.
 In standard mode, the vertical direction is the paper feed direction, and the
horizontal direction is perpendicular to the paper feed direction. However, when
character orientation changes in 90clockwise-rotation mode, the relationship
between vertical and horizontal directions is reversed.