Bematech LR2000 - Page 74

LR2000 Programming Manual V1.2
2,50
Printer status print
3,51
Rolling pattern print
[Notes]  This command has enabled only when processed at the beginning of a line in
standard mode.
 This command is no effect in page mode.
 When this command is received during macro definition, the printer ends macro
definition and begins performing this command.
 After the test print is finished, the printer resets itself automatically. Therefore, data
already defined before this command is executed, such as user-defined characters,
downloaded bit image, and macro, becomes undefined;
 The printer cuts the paper at the end of the test print.
 The printer goes BUSY while this command is executed.
GS ( F pL pH a m nL nH
[Name] Set black mark adjustment value
[Format] ASCII GS ( F pL pH a m nL nH
Hex 1D 28 46 pL pH 61 m nL nH
Decimal 29 40 70 pL pH 97 m nL nH
[Range] (pL+pHx256) = 4 (where pL = 4, pH = 0)
1 ≤ a ≤ 2
m = 0,1
0 ≤ nL ≤ 255, 0 ≤ nH ≤ 255
[Description] Sets the adjustment value of the black mark detection position.
a specifies the type of adjustment value.
a
Function
1
Sets the adjustment value of the black mark detection position.
2
Sets the adjustment value of the paper cutting position after black
mark detection.
m specifies the direction of adjustment
m
Function
0
Forward Direction (Paper Feed Direction)
1
Reverse Direction
nL, nH specify the amount of adjustment. Adjustment = (nH×256 + nL) × 0.141mm.
[Notes]  When processing this command while defining a macro, the macro definition is
immediately terminated and the command commences with processing.