1.5.1 Checking Drive Belt Tension
Lay a tape measure on the cable track with 0 on the ruler positioned where the Drive Belt
enters the Drive Belt Clamp Block. Using the Belt Tension Tool from the Miscellaneous box,
position the tool one foot from the Drive Belt Clamp Block. Place a nger under the Drive Belt
two feet from the end of the Drive Belt Clamp Block. Push straight down on the Belt Tension
Tool with the right index nger while supporting the Drive Belt with the left hand. When the Belt
Tension Tool clicks, observe where the top face of the lever crosses the plane on the body of
the tool. This position indicates belt tension.
Improper Drive Belt tension will lead to inconsistent Trolley operation.
1 ft. 2 ft.
Belt Tension 120 lbs
Belt Tension Tool
13Bend-Tech Dragon A400
Start-Up and Training
Setup Inspection
01
To Next Page
Loading...
