iv Bend-Tech Dragon A400
Start-Up and Training Manual
Contents
Contents ...................................iv
01
Setup Inspection...................... 7
1.1 General Overview ...............7
1.2 Rail ..........................8
1.2.1 Rail Assembly ..............8
1.2.2 Checking Rail Level ..........8
1.2.3 Checking Rail Straightness ....8
1.2.4 Rail Splices ................8
1.3 Trolley. . . . . . . . . . . . . . . . . . . . . . . . . 9
1.3.1 Trolley Cover ...............9
1.3.2 Trolley Bearing Adjustment ... 10
1.3.3 Trolley Operation ........... 10
1.4 Drive Belt Alignment ..............11
1.4.1 Drive Pulley Spacing .........11
1.4.3 Drive Belt Clamp ........... 12
1.5 Drive Belt Tension Procedure ..... 12
1.5.1 Checking Drive Belt Tension .. 13
1.5.4 Drive Belt Tension Nut ....... 14
1.5.5 Adjusting Belt Tension ....... 14
1.5.6 Locking Drive Belt Tension ... 14
1.6 Control Box ................... 15
1.6.1 C Axis Control Box .......... 16
1.6.2 Main Power Cord ........... 16
Contents
1.6.3 Main Power Switch ......... 16
1.6.4 Main Power Fuses .......... 16
1.6.5 Breakout Board ............ 17
1.6.7 Motor Cables .............. 18
1.6.8 Motor Location and Operation
Index ......................... 18
1.6.9 Axis Sensor Cables ......... 18
1.6.10 E-Stop Cables ............ 19
1.6.11 Ethernet Port ............. 19
1.6.12 Air Line Connection ........ 20
1.6.13 Laser Cord ............... 20
1.6.14 Tool Connections .......... 20
1.7 Power and Control Connections ... 21
1.7.1 Cable Connections ......... 21
1.7.2 Motor Connections. . . . . . . . . . 21
1.7.3 Motor Connector Check ...... 21
1.7.4 Sensor Connections ........ 22
1.7.5 Air Line Connections ........ 22
1.7.6 Ground Cable ............. 23
02
Machine Walk Through .......... 25
2.1 Machine Overview .............. 25
2.2 Gate ........................ 25
2.2.1 Gate Overview ............. 26
2.2.2 Gate Eccentric Bearing ...... 26
To Next Page
Loading...
