43Bend-Tech Dragon A400
Start-Up and Training
Machine Control Startup
03
3.2.1 Power On Computer
Power on the Computer by pressing the power
button located on the front of the unit. Make sure
the power cord is plugged in to a reliable power
source. It is highly recommended that electronics
such as the Dell Inspiron be protected from power
surges by surge protector. This will insure that,
should there be power uctuations in the building,
the Dragon A400 control software system will be
protected.
3.3 Power On Control Box
The Operator should have thoroughly inspected the Control Box according to procedure
in Chapter 1. The Operator should have thoroughly inspected all electrical connections,
components and operation according to procedure in Chapter 2. Following these procedures
ensures the Dragon A400 electrical control system is set up and properly and ready for
operation.
! Caution !
Do not open Mach 3 or Bend-Tech software at this time.
USB Ports
Power Switch
To Next Page
Loading...
