1.6.10 E-Stop Cables
There are three E-Stop cables located in the upper right corner of the Control Box. The E-Stop
cables are at the bottom of the group of cables located in that position. Assure the E-Stop
Cables are securely seated and tightened in their Control Box connections.
1.6.11 Ethernet Port
The Ethernet Port is located near the center of the Control Box. Ensure the Ethernet cable
that connects the Dragon A400 computer to the Control Box is connected and seated in the
Ethernet Port cable receptacle, and that it is securely clipped in place.
Ensure the Ethernet cable is connected directly to the computer. Do not use adapters.
A link light at the Ethernet port indicates proper connection.
It is important to route the Ethernet cable away from the Torch cable as well as other
electrical feed to ensure proper signal, and avoid electrical interference
While there are four E-Stop buttons, only three E-Stop cables connect at the Control
Box. It does not matter in what order the E-Stop cables are connected at the Control
Box.
19Bend-Tech Dragon A400
Start-Up and Training
Setup Inspection
01
To Next Page
Loading...
