1.6.1 C Axis Control Box
On Dragon A400 machines with a Powered
Gate, the Control Box will be equipped with
a C Axis Control Box piggybacked onto the
Control Box. Ensure the C Axis Control Box
is securely mounted on the Control Box and
that the cables are tightened securely in their
connections.
1.6.2 Main Power Cord
The Main Power Cord connects to the Control
Box in the black hexagonal port just under the
Engraver (E) Air Line Connection. Ensure the
Main Power Cord is seated in its connection.
1.6.3 Main Power Switch
The Main Power Switch is located just above the Main Power Cord. The Main Power Switch
should be o (the O side depressed) while inspecting and servicing the machine.
1.6.4 Main Power Fuses
The Main Power Fuse is located in a slot just below the Main Power Cord. To access the Main
Power Fuse, remove the Main Power Cord from its socket and use a nger to slide out the
Main Power Fuse holder. For Main Power Fuse location see Control Box diagram, section 1.6.
Not all machines will use the C and Gate connections.
Main Control Box
C Axis
Control Box
16 Bend-Tech Dragon A400
Start-Up and Training
Setup Inspection
01
To Next Page
Loading...
