52 Bend-Tech Dragon A400
Start-Up and Training
Machine Control Startup
03
3.5.5 Home All Axis
The Operator has the ability to home each feature individually
or choose HOME ALL AXIS. Upon initial machine startup
the operator should choose HOME ALL AXIS and allow the
machine to complete this action.
Click HOME ALL AXIS. This procedure will take a few minutes.
The Operator should observe the procedure to ensure all Axes
are safely homed by the program with no interference.
3.6 Hypertherm
Powering on the Hypertherm plasma cutting machine is the last step in preparing the Dragon
A400 to run. The Operator should have set up and connected the Hypertherm according to the
procedures outlined in Chapter 2.7.
Ensure the Hypertherm unit is set to cut the type of material or to perform the cutting
procedure as intended. The Hypertherm will go to default PSI settings. However, the
Operator will need to adjust amperage as necessary.
House icons will turn green when the Axis is homed.
To Next Page
Loading...
Need help?
General
