32 Bend-Tech Dragon A400
Start-Up and Training
Machine Walk Through
02
2.4.2 Toolhead Actuators
The Toolhead is controlled
by the A Axis and Z Axis
motors. The motors use
Actuators to perform vertical
and horizontal movement of
the Toolhead. The Actuators
should be kept clean and
free of dust and debris. The
Actuators are key to smooth,
precise and consistent
operation of the Toolhead.
The Marker, Engraver and Torch are mounted left to right on the Toolhead to coincide
with the order of operation for each tool.
Torch
Laser Light
Z Axis Motor
Marker Housing
Engraver
A Axis Motor
A Axis Motor
Z Axis Motor
Vertical Actuator
Screw
Horizontal
Actuator Screw
To Next Page
Loading...
