16 Bend-Tech Dragon A400
Assembly Manual
Beginning Assembly
03
Begin the assembly process by disassembling the crate. The Installer should remove the
fastening one of the two larger crate sides, then remove the two smaller crate sides. Remove
the remaining large crate side.
3.3 Getting Started
Uncrating the Dragon A400 components properly, and in the proper order, is critical to
achieving the quickest, most seamless installation possible. As shipped, the components of
together or shrink-wrapped together.
3.3.1 Component Boxes
Remove the various component boxes packed around the Dragon A400 machine. The
Component Boxes will be labeled for reference during the assembly process.
Tools Needed
• ½ in. wrench or ½ in. socket and ratchet
! Caution !
Enlist the help of additional personnel when uncrating the machine. A dropped
crate component could cause injury to the Installer or other personnel. A dropped
crate component could damage the machine. Crate sides are large and heavy and
should not be lifted without help.
Do not remove any strapping or shrink wrap from the head of the Dragon A400. The
Head will be removed last, and it is important to keep its components secure while it is
being removed from the crate.
To Next Page
Loading...
