52 Bend-Tech Dragon A400
Assembly Manual
Mounting to the Floor
10
10.3 Preparing the Floor Brackets
With the machine level and true, loosen the Floor Brackets on the Rail Support Legs so they
Removing the Floor Brackets makes it easier to drill the holes for the concrete sleeve anchors.
holes are drilled, clean the holes out with a vacuum or compressed air and re-install the Floor
Brackets. Do not tighten the Floor Brackets onto the Rail Beam Support Legs at this time.
If mounting with more than one concrete sleeve anchor per Floor Bracket, typical
concrete sleeve anchor spacing is 10 fastener diameters apart.
When placing concrete sleeve anchors ensure the machine will be able to move side
to side in the mounting slots in case future alignment is required.
To Next Page
Loading...
