18 Bend-Tech Dragon A400
Assembly Manual
Beginning Assembly
03
3.4 Miscellaneous Box
Button Cap Screws. These will be needed to assemble the Rail and Rail Beam in preparation
for installing the Head of the machine.
3.5 Swivel Levelers
Remove six of the Swivel Levelers from their packaging. Thread the jam nut to the bottom of
the Leveler near the adjustment hex just above the swiveling foot. Enlisting help to lift the Rear
Leveler into the threaded hole at the bottom
of each leg on the Rear Tail Section Rail
Supports. Leave about an inch of thread
between the leg and the adjustment hex.
Using a ½ in. socket and ratchet or ½ in.
wrench, remove the Rail Support from the
crate that was nearest the Rear Tail Section.
Install a Swivel Leveler into the threaded
hole in the bottom of each leg. Leave about
an inch of thread between the leg and the
adjustment hex.
Tools Needed
• ½ in. Wrench
Hardware Needed
• Swivel Levelers
The Dragon A400 Rail Support Legs are mounted to the oor of the shipping crate
using the Floor Brackets. When assembling the machine, the Floor Brackets should be
left in place. The Installer will use the Swivel Levelers to true the machine then bolt it
to the oor using the Floor Brackets.
Swivel
Leveler
Leg Bracket
To Next Page
Loading...
