ATICS-2-ISO_D00046_04_M_XXEN / 03.2021 103
ATICS-2-63A-ISO
Type Nominal voltage U
n
Rated operational current I
e
Art. No. Manual No.
ATICS-BP-2-63A-SET
SET
Bypass switch set (I
e
: AC 63 A) comprising:
• Bypass switch 63 A single, 2-pole, sequence of operation: I-I+II-II, with
auxiliary contact, bridge, terminal cover
• Auxiliary contact for ATICS®
• LEDs green/red for DIN rail mounting
B92057252 D00162
ATICS-BP-2-80A-SET
SET
Bypass switch set (I
e
: AC 80 A) comprising:
• Bypass switch 80 A single, 2-pole, sequence of operation: I-I+II-II, with
auxiliary contact, bridge, terminal cover
• Auxiliary contact for ATICS®
• LEDs green/red for DIN rail mounting
B92057253 D00162
EDS151 Insulation fault locator B91080101 D00107
ESS3680
Transformer 3�68 kVA, AC 400 V / 230 V
For "ATICS® for 400 volt systems without N conductor", only the trans-
formers recommended by Bender (T5, T6) may be used!
B924744
ATICS-ES Energy storage device for ATICS-2-63A-ISO-ES and ATICS-2-80A-ISO-ES B72057255 D00009
AN412 Power supply unit DC 12 V for ATICS-ES energy storage device B924150
Description ATICS-2-...-ISO:
2-pole transfer switching and monitoring device with integrated insulation, load and temperature mon-
itoring of the IT system, 1 dig. input, 1 relay output, short-circuit detection in TN systems, with sealable
contact covers on the input and output sides, bridges on the output side and pluggable screw-type ter-
minals for all connections. Measuring current transformers STW2 and STW3.
* with connection option for ATICS-ES energy storage device.
10.6 Additional documents
• ATICS® quick-start guide "ATICS-2-ISO...DEEN" (D00046)
• ATICS® Checklist
In addition, the following instructions apply:
• ATICS-BP-SET (bypass switch set for ATICS®)
• STW2, STW3, STW4 measuring current transformers
• BMS bus Bender measuring device interface
• COM465… BMS-Ethernet gateway for the connection of the Bender measuring device inter-
face to TCP/IP networks
• EDS150 insulation fault locator
• EDS151 insulation fault locator
• MK2430 alarm indicator and test combination
• MK800 alarm indicator and test combination
• TMK-SET configuration software for MK2430, MK800 and TM800
• CP9xx - Control Panel
To Next Page