Bender ATICS-2-63A-ISO - Connection Example: ATICS for 400-Volt Systems with N Conductor

36 ATICS-2-ISO_D00046_04_M_XXEN / 03.2021
Mounting and connection
4.2.6 Connection example: ATICS® for 400-volt systems with N conductor
I
Warning! Risk of destruction if connected incorrectly.
The terminals marked with "*" are intended for Bender-internal purposes only. If this is ignored, the
ATICS® automatic transfer switching and monitoring device may be damaged.
I
risk of ineffective voltage monitoring.
The ATICS® must be supplied with power directly from the connected line (not from another phase)
as shown. If this is not observed, the voltage monitoring does not function.
*An diese Klemmen ausschließlich ATICS-ES
an Variante ATICS-2-ISO-xx-ES anschließen!
*Solely connect ATICS-ES to variant
ATICS-2-ISO-xx-ES with these terminals!