11
MK2430_D00129_02_M_XXEN/09.2019
2. Safety instructions
2.1 General safety instructions
Part of the device documentation in addition to this manual is the enclosed " Safety in-
structions for Bender products".
Bender devices are built in accordance with state-of-the-art technology and accepted
recognised safety regulations. However, the use of such devices may introduce risks to
the life and limb of the user or third parties and/or result in damage to the Bender devices
and other property.
Only use Bender devices:
– As intended
– In perfect working order
– In compliance with the accident prevention regulations and the guidelines
applicable at the location of use
Immediately rectify any faults that may endanger safety.
Do not make any unauthorised changes and only purchase spare parts and
optional accessories recommended by the manufacturer of the devices. Failure to
observe this requirement can result in fire, electric shock and injury.
Reference signs must always be clearly legible. Replace damaged or illegible signs
immediately.
Make sure that the dimensions of the BSV (battery-supported safety power supply), the
generator set and the whole wiring is adequate. The applicable national and interna-
tional standards must be observed here. Only in this way selective operation of safety
devices can be achieved and a high degree of safety in case of overload and short circuit
can be ensured.
2.2 Work activities on electrical installations
Only qualified personnel are permitted to carry out the work necessary to
install, commission and run a device or system.
To Next Page
Loading...
Need help?
General
