53
MK2430_D00129_02_M_XXEN/09.2019
8. Menu mode: Operation and setting
8.1 Switching on and calling up the main menu
If the MK2430 is connected to the voltage supply, the following information appears on
the display for approx. 3 seconds. Details about the address and the firmware version of
the device are displayed. This information is also available in the "Info" menu.
If there are no messages pending, the standard display will be shown when the starting
procedure is completed.
The TMK-SET software allows you to change the standard display and the message
texts.
If the MK2430 has not been turned on for several days, a longer time may
be required for start-up (approx. 30 seconds). In this case, enter the time
and date again.
MK2430-11 Addr.:001
Software 4.02 D228
Date: 02.05.12
www.bender.de
To Next Page
Loading...
