Safety instructions
12
MK2430_D00129_02_M_XXEN/09.2019
If the device is being used in a location outside the Federal Republic of Germany, the
applicable local standards and regulations must be complied with. European standard
EN 50110 can be used as a guide.
2.3 Intended use
The universal MK2430 alarm indicator and test combination is used for visual and
acoustic indication of operating status and alarm messages from Bender's EDS, RCMS,
ATICS® and MEDICS® systems. In MEDICS® monitoring systems, the MK2430 meets the
requirements of IEC 60364-7-710:2002-11 and DIN VDE 0100-710:2002-11 with regard
to test functions for IT system monitoring and alarms from changeover devices. IT
system monitoring equipment can be tested using the programmable "TEST" button.
Important display functions:
Normal operation indicator (green LED)
Insulation fault
Overload
Overtemperature
Messages from EDS… insulation fault location systems and RCMS… residual cur-
rent monitoring systems
Interruption of the system conductor or PE conductor connection of the ISOME-
TER®
Supply line failure
Power supply fault conditions and changeover device faults
Device failure
Test results
Measured values
Risk of fatal injury due to electric shock!
Touching live parts of the system carries the risk of:
An electric shock
Damage to the electrical installation
Destruction of the device
Before installing and connecting the device, make sure that the
installation has been de-energised. Observe the rules for working on
electrical installations.
Refer to the rated and supply voltage values as specified in the
technical data!
To Next Page
Loading...
Need help?
General
