3 Installation and Settings
19 / 64
Figure 27 Bridge-Repeater Mode
Go to LAN to set, as shown in the figure below:
Figure 28 Bridge-Repeater Mode
Ipv4 Settings：Static configure IP address, fill in IP address and mask.
Ipv6 Settings：No need to change if the user does not use Ipv6.
3.4.4 Select Router-AP Mode
Router-AP：Under Router-AP mode, WLAN works under AP mode, Ethernet port as
WAN port to transfer data.
Router-AP work mode basic configuration, as shown in the figure below：
To Next Page
Loading...