3 Installation and Settings
34 / 64
WDS：Allow other equipment to link to the Clients via AP.
ExtAP：Allow other e quipment to link to cli ents via AP. It is mainly used when AP
cannot open WDS. It is recommended to use WDS.
KeepAP：Only used in the Rel ay Mode. When the Client does not lin k t o A P i n
previous level, still open AP interface. The interface comes into effect after reboot.
3.5.3 Advanced Settings
Open “Wireless→Advanced”.
Figure 59 VAP Advanced Configuration
Signal Mark Frame Interval：Set the signal mark frame i nterval time . Signal
mark frame is used for broadcasting AP name.
DTIM Cycle：DTIM (delivery traffic indica tion messa ge), is a kind of transmission
indication message(TIM),is used to tell the Clie nt that there is a buffer
broadcast/single cast data in AP. DTIM Cycl e sets the client dormant time based on
signal mark frame counting.
WMM：WMM(Wi-Fi Multimedia)：Provide basic QoS (Quality of service) function for
802.11. The power saving function is also realized in WMM.
Short Front Code：Long front code is compatible with the old 11b equipment.
Using short front code can attain a higher transmission rate.
BG Protection Mode：Open 802.11g protection mode, v802.11b equipment can be
inspected to be going to send RTS/CTS or der in 802.11g network. This function can
be used to protect the frame equipment which cannot recognize OFDM modulation.
RTS/CTS： RTS/CTS protocol (Request to send/Clear to send), that is Request
sending/clear sending protocol, a mechanism which is adopted b y 802.11 wireless
protocols to reduce the conflicts caused by hiding node.
Client Number：Currently, this access point supports the maximum number of255
Clients.
Note：This Client restriction opti on only ap pears unde r AP mode and Repeater
mode.
Note：Repeater mode distinguishes between wlan1-STA port and wlan0-AP port.
To Next Page
Loading...