BIFFI ICON 2000 - Page 76

76
© Copyright by BIFFI Italia. All rights reserved.
“ICON2000”
instruction and operating manual
Section 618/2 chapt. I
Section 618/2
3.5 CLEAR RECENT DATA LOG
The clear recent data log routine allows to clear the counters of the recent operation log.
This command does not affect the content of the “general operation log”.
The date of the “clear recent data log” is memorised and can be viewed in the maintenance
date routine of the view menu.
Clearing procedure:
• Move the local selector to OFF and then simultaneously press OPEN and STOP. Select
the language and enter the password according to the instructions (see “Entering the set-
up mode”.) When the message displayed is “SET-UP MODE OK?” press YES. Press NO
to scroll the list of available menus and press YES to select the maintenance menu.
• Press NO to scroll the list of available routines and then press YES to select clear recent
data log.
• Press YES
• Press YES to clear or press NO to exit.
3.6 SET MAINTENANCE DATE
The maintenance date routine allows the following operations:
• to set the last maintenance date
• to set the next maintenance date
• to set the start-up date
Configuration procedure:
• Move the local selector to OFF and then simultaneously press OPEN and STOP. Select
the language and enter the password according to the instructions (see “Entering the set-
up mode”). When the message displayed is “SET-UP MODE OK?” press YES. Press NO
to scroll the list of available menus and then YES to select the maintenance menu.
• Press NO to scroll the list of available routines and press YES to select maintenance date.
• Press YES to set the last maintenance date. Press NO to skip to “next maintenance date”.
Last maintenance date:
• Press YES if the date is correct, press NO to change it
• Enter day, month, and year. Press NO to scroll the list of available values, press YES to
select
• Press YES if the date is correct
Next maintenance date:
• Press YES if the date is correct, press NO to change it
• Enter day, month, and year. Press NO to scroll the list of available values, press YES to
select
• Press YES if the date is correct
Start-up date:
• Press YES if the date is correct, press NO to change it
• Enter day, month, and year. Press NO to scroll the list of available values, press YES to
select
• Press YES if the date is correct