Field Description
tunnel setup should be transmitted with the UMTS/LTE callback
call under Transfer own IP address over ISDN/GSM . This
may shorten and simplify tunnel setup.
PUK This is only displayed if the device has made three failed at-
tempts to establish a connection, e.g. if the PIN for the SIM card
(see the SIM Card Uses PIN field) has been entered incorrectly
three times.
Enter the PUK (personal unblocking key) for your SIM card to
unblock the SIM card.
SIM Card Uses PIN Only for UMTS/LTE Status = "1
Enter the PIN for your UMTS/LTE modem card.
Note
Entering a wrong PIN blocks communication until the entry
is corrected.
Note
If the device has made three failed attempts to establish a
connection, e.g. because the PIN has been entered incor-
rectly three times, you will need to enter the PUK in order
to unblock the SIM card.
Fallback Number Only for UMTS/LTE Status = "1
Enter the call number for the GSM fallback function.
When a voice calls goes in on this number, any active connec-
tion is immediately disconnected and the operating mode of the
modem reset to GSM, where the modem remains until another
data call (PPP, ISDN login, IPSec callback) comes in. If flat-rate
mode is enabled for the WAN connection (option Always active
enabled in WAN->Internet + Dialup->UMTS/LTE-> ), this
means that the connection will be re-established immediately.
bintec elmeg GmbH
8 Physical Interfaces
bintec RS Series 127
To Next Page
Loading...
