You can configure your device in the following ways:
• GUI
• Assistant
• SNMP shell commands
Note
The detailed help system of the Wizard will help you to clarify any questions you may
have. Therefore the wizard will not be discussed in any greater detail in this document.
The configuration options available to you depend on the type of connection to your device:
Types of connections and configurations
Type of connection Possible types of configuration
LAN Assistant, GUI, shell command
console connection Shell command
The following chapters describe the configuration based on GUI.
Note
To change the device configuration, you must log in with the user name %!. If you
do not know the password, you cannot make any configuration settings. This applies to
all types of configuration.
5.3.1 GUI (Graphical User Interface)
GUI is a web-based graphic user surface that you can use from any PC with an up-to-date
Web browser via an HTTP or HTTPS connection.
With the GUI you can perform all the configuration tasks easily and conveniently. It is integ-
rated in your device and is available in English. If required, other languages can be down-
loaded from the download area of www.bintec-elmeg.com and installed on your device. To
do this, proceed as described in Options on page 486.
The settings you make with the GUI are applied with the OK or Apply button of the menu,
and you do not have to restart the device.
If you finish the configuration and want to save your settings so that they are loaded as the
5 Access and configuration bintec elmeg GmbH
38 bintec RS Series
To Next Page
Loading...
