Field Description
liseconds.
The value can only be modified for Roaming Profile = 6
@#. The default value is .
10.1.2 Wireless Networks (VSS)
If you are operating your device in Access Point Mode ( Wireless LAN->WLAN->Radio
Settings-> ->Operation Mode = 3%% / :# 09 '), in the
menu Wireless LAN->WLAN->Wireless Networks (VSS)-> / New you can edit the
wireless networks required or set new ones up.
Note
The preset wireless network default has the following security settings in the ex works
state:
• Security Mode = 23 4
• WPA Mode = 23 23
• WPA Cipher as well as WPA2 Cipher = 3 *4
• The Preshared Key is filled with an internal system value, which you must change
during configuration.
Setting network names
In contrast to a LAN set up over Ethernet, a wireless LAN does not have any cables for set-
ting up a permanent connection between the server and clients. Access violations or faults
may therefore occur with directly adjacent radio networks. To prevent this, every radio net-
work has a parameter that uniquely identifies the network and is comparable with a domain
name. Only clients with a network configuration that matches that of your device can com-
municate in this WLAN. The corresponding parameter is called the network name. In the
network environment, it is sometimes also referred to as the SSID.
Protection of wireless networks
As data can be transmitted over the air in the WLAN, this data can in theory be intercepted
and read by any attacker with the appropriate resources. Particular attention must therefore
be paid to protecting the wireless connection.
There are three security modes, WEP, WPA-PSK and WPA Enterprise. WPA Enterprise of-
10 Wireless LAN bintec elmeg GmbH
152 bintec RS Series
To Next Page
Loading...
