fields:
Fields in the menu Basic Parameters
Field Description
Route Type Select the type of route.
Possible values:
• 5$1 @ $%: Route via a specific in-
terface which is to be used if no other suitable route is avail-
able.
• 5$1 @ 7(: Route via a specific gate-
way which is to be used if no other suitable route is available.
• ? @ $%: Route to an individual host
via a specific interface.
• ? @ 7(: Route to an individual host via
a specific gateway.
• )79 @ $% (default value): Route to
a network via a specific interface.
• )79 @ 7(: Route to a network via a
specific gateway.
Only for interfaces that are operated in DHCP client mode:
Even if an interface is configured for DHCP client mode, routes
can still be configured for data traffic via that interface. The set-
tings received from the DHCP server are then copied, along
with those configured here, to the active routing table. This en-
ables, e. g., in the case of dynamically changing gateway ad-
dresses, particular routes to be maintained, or routes with differ-
ent metrics (i. e. of differing priority) to be specified. However, if
the DHCP server sends static routes, the settings configured
here are not copied to the routing.
• 5$1 @ *+1 + 5?6: The routing in-
formation is taken entirely from the DHCP server. Only ad-
vanced parameters can be additionally configured. This route
remains unchanged by other routes created for this interface
and is copied to the routing table in parallel with them.
• ? @ *+1 + 5?6: The settings received
by DHCP are supplemented by routing information about a
particular host.
• )79 @ *+1 + 5?6: The settings re-
12 Networking bintec elmeg GmbH
210 bintec RS Series
To Next Page
