Field Description
within the existing connection are allowed.
In the NAT Configuration->Specify original traffic menu, you can configure for which
data traffic NAT is to be used.
Fields in the menu Specify original traffic
Field Description
Service Not for Type of traffic = ## % )3*! and NAT
method = $11 %, % % or +
% %.
Select one of the preconfigured services.
Possible values:
• . $ (default value)
• A% B
Action Only for Type of traffic = >%1# 2 )3*!
Select which data packets are to be excluded by NAT.
Possible values:
• >%1 (default value): All the data packets that match the
following parameters that are to be configured (protocol,
source IP address/network mask, destination IP address/net-
mask, etc.) are excluded by NAT.
• 5 >%1: All the data packets that do not match the
following parameters that are to be configured (protocol,
source IP address/network mask, destination IP address/net-
mask, etc.) are excluded by NAT.
Protocol Only for certain services.
Not for Type of traffic = ## % )3*! and NAT
method = $11 %, % % or +
% %. In this case UDP is automatically defined.
Select a protocol. According to the selected Service, different
protocols are available.
Possible values:
bintec elmeg GmbH
12 Networking
bintec RS Series 221
To Next Page
Loading...
