Fields in the Basic Parameters menu.
Field Description
Class map Choose the class plan you want to create or edit.
Possible values:
• )7 (default value): You can create a new class plan with this
setting.
• A) $ %1 +1B: Shows a class plan that has
already been created, which you can select and edit. You can
add new filters.
Description Only for Class map = )7
Enter the name of the class plan.
Filter Select an IP filter.
If the class plan is new, select the filter to be set at the first point
of the class plan.
If the class plan already exists, select the filter to be attached to
the class plan.
To select a filter, at least one filter must be configured in the
Networking->QoS->QoS Filter menu.
Direction Select the direction of the data packets to be classified.
Possible values:
• %#: Incoming data packets are assigned to the class
(Class ID) that is then to be defined.
• -## (default value): Outgoing data packets are as-
signed to the class (Class ID) that is then to be defined.
• :: Incoming and outgoing data packets are assigned to
the class (Class ID) that is then to be defined.
High Priority Class Enable or disable the high priority class. If the high priority class
is active, the data packets are associated with the class with the
highest priority and priority 0 is set automatically.
The function is enabled with "1.
12 Networking bintec elmeg GmbH
238 bintec RS Series
To Next Page
Loading...
