Field Description
You can define a filter that takes the status of the TCP connec-
tions into account.
Possible values:
• 3( (default value): All TCP packets match the filter.
• "1: All TCP packets that would not open any new
TCP connection on routing over the gateway match the filter.
Destination IP Ad-
dress/Netmask
Enter the destination IP address and netmask of the data pack-
ets.
Possible values:
• 3( (default value)
• ?: Enter the IP address of the host.
• )79: Enter the network address and the related net-
mask.
Destination Port/Range
Only if Protocol = *6, .5
Enter a destination port number or a range of destination port
numbers that matches the filter.
Possible values:
• 311 (default value): The filter is valid for all port numbers
• +%$( +: Enables the entry of a port number.
• +%$( + #: Enables the entry of a range of port
numbers.
Source IP Address/
Netmask
Enter the source IP address and netmask of the data packets.
Source Port/Range
Only if Protocol = *6, .5
Enter a source port number or the range of source port num-
bers.
Possible values:
• 311 (default value): The filter is valid for all port numbers
• +%$( +: Enables the entry of a port number.
• +%$( + #: Enables the entry of a range of port
bintec elmeg GmbH
12 Networking
bintec RS Series 251
To Next Page
Loading...
