Field Description
Block Time Define how long a peer is blocked for tunnel setups after a
phase 1 tunnel setup has failed. This only affects locally initiated
setup attempts.
Possible values are to (seconds); means the
value in the default profile is used and means that the peer is
never blocked.
The default value is &.
NAT Traversal NAT Traversal (NAT-T) also enables IPSec tunnels to be
opened via one or more devices on which network address
translation (NAT) is activated.
Without NAT-T, incompatibilities may arise between IPSec and
NAT (see RFC 3715, section 2). These primarily prevent the
setup of an IPSec tunnel from a host within a LANs and behind
a NAT device to another host or device. NAT-T enables these
kinds of tunnels without conflicts with NAT device, activated
NAT is automatically detected by the IPSec Daemon and NAT-T
is used.
Only for 4 +$1
Possible values:
• "1 (default value): NAT Traversal is enabled.
• 5"1: NAT Traversal is disabled.
• <%: The device always behaves as it would if NAT were in
use.
Only for 4 +$1
The function is enabled with "1.
The function is enabled by default.
CA Certificates Only for Phase-1 (IKE) Parameters
Only for Authentication Method = 53 #, @3
# or @3 %(+
If you enable the Trust the following CA certificates option,
you can select up to three CA certificates that are accepted for
this profile.
16 VPN bintec elmeg GmbH
348 bintec RS Series
To Next Page
Loading...
