BinTec RS353j - Chapter 19 Local Services

Field Description
Action Select the action to be applied to a filtered packet.
Possible values:
• 3%% (default value): The packets are forwarded on the
basis of the entries.
• 5(: The packets are rejected.
• @L%: The packets are rejected. An error message is is-
sued to the sender of the packet.
Apply QoS Only for Action = 3%%
Select whether you want to enable QoS for this policy with the
priority selected in Priority.
The function is enabled with "1.
The option is deactivated by default.
If QoS is not activated for this policy, bear in mind that the data
cannot be prioritised on the sender side either.
A policy for which QoS has been enabled is also set for the fire-
wall. Make sure therefore that data traffic that has not been ex-
pressly authorised if blocked by the firewall!
Priority Only for Action = 3%% and Apply QoS = "1
Select the priority with which the data specified by the policy is
handled on the send side.
Possible values:
• ) (default value): No priority.
• 07 0%(: Low Latency Transmission (LTT), i.e. hand-
ling of data with the lowest possible latency, e.g. suitable for
VoIP data.
• ?#
• '
• 07
bintec elmeg GmbH
17 Firewall
bintec RS Series 387