Field Description
Select the type.
Possible values: 3(, % +1(, 5 %
"1, % ;%, @%, %, * >%,
*+, *+ +1(.
See RFC 792.
The default value is 3(.
Connection State With Protocol = *6, you can define a filter that takes the
status of the TCP connections into account.
Possible values:
• "1: All TCP packets that would not open any new
TCP connection on routing over the gateway match the filter.
• 3( (default value): All TCP packets match the filter.
Destination IP Ad-
dress/Netmask
Enter the destination IP address of the data packets and the
corresponding netmask.
Destination Port/Range Only for Protocol = *6 or .5
Enter a destination port number or a range of destination port
numbers.
Possible values:
• 311 (default value): The destination port is not specified.
• +%$( +: Enter a destination port.
• +%$( + #: Enter a destination port range.
Source IP Address/
Netmask
Enter the source IP address of the data packets and the corres-
ponding netmask.
Source Port/Range
Only for Protocol = *6 or .5
Enter a source port number or a range of source port numbers.
Possible values:
• 311 (default value): The destination port is not specified.
• +%$( +: Enter a destination port.
• +%$( + #: Enter a destination port range.
19 Local Services bintec elmeg GmbH
470 bintec RS Series
To Next Page
Loading...
