Field Value
The default value is (1 second).
Alive Check Here you can activate a check of the accessibility of a RADIUS
server in Status 57 .
An Alive Check is carried out regularly (every 20 seconds) by
sending an ACCESS_REQUEST to the IP address of the RADI-
US server. If the server is reachable, Status is set to
1 again. If the RADIUS server is only reachable over a
switched line (dialup connection), this can cause additional
costs if the server is 7 for a long time.
The function is activated by selecting "1.
The function is enabled by default.
Retries Enter the number of retries for cases when there is no response
to a request. If an response has still not been received after
these attempts, the Status is set to 7. In Alive Check =
"1 your device attempts to reach the server every 20
seconds. If the server responds, Status is set back to 1 .
Possible values are whole numbers between and .
The default value is . To prevent Status being set to 7, set
this value to .
RADIUS Dialout Only for Authentication Type = 3% and
% 3%.
Select whether your device receives requests from RADIUS
server dialout routes. This enables temporary interfaces to be
configured automatically and your device can initiate outgoing
connections that are not configured permanently.
The function is activated by selecting "1.
The function is disabled by default.
If the function is active, you can enter the following options:
• @1 1: Enter the time period in seconds
between update intervals.
The default entry here is i.e. an automatic reload is not car-
7 System Management bintec elmeg GmbH
84 bintec RS Series
To Next Page
Loading...
